ULN2003 Stepper Motor Driver
The ULN2003 stepper motor driver board allows you to easily control the 28BYJ-48 stepper motor from a microcontroller, like the Arduino Uno. One side of the board side has a 5 wire socket where the cable from the stepper motor hooks up and 4 LEDs to indicate which coil is currently powered. The motor cable only goes in one way, which always helps. On the side, you have a motor on/off jumper (keep it on to enable power to the stepper).
Features:
Package List:
Documents:
28BYJ-48 Stepper Motor-5V
The 28BYJ-48 is a small, cheap, 5 volt geared stepping motors. These stepping motors are apparen..
$0.80
L9110 Dual-Channel H-Bridge Motor Driver Module - 12V 800mA
L9110, The ASIC device control and drive motor design two-channel push-pull power amplifier discre..
$1.00
A4988 Stepper Motor Driver
The A4988 is a complete microstepping motor driver with built-in translator for easy operation. It..
$1.10
DRV8825 Stepper Motor Driver
This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustabl..
$3.20