Solving the DDR Connector Problem | Makerfabs

Posted by Sammaker 07/12/2018 0 Comment(s)


There are many uncertainties in the lab, not to mention the production. Machine, materials, tools even air humidity or temperature could effect the finished product.


Last week we came up with some problems during a PCBA manufacturing project from UK, the DDR Connector couldn’t attach to the board 100%, which would lead to big risk on the soldering quality.


As the picture, the DDR connector length is more than 70mm and the fixture Plastic material, the connector is easy to get a little bent, and one end of Pins can’t touch the pads well. 


After discussing with the technical team, we decided use fixture, made of a special material to connectors touch the board completely. Problem solved! We wish our experience and solution could be helpful to those that also suffers this problem.


This is just a small episode of our countless projects, as the first phase said, there are many uncertainties in the lab, in the factory, we can’t predict what will happen, but we Makerfabs will finger out the most suitable solution for each client. From material purchase to prototyping and small batch production, we control each phase strictly to make sure the defective percentage reduce to the minimum.


We hope that Makerfabs can supply full support for each maker, engineer, startup company, this “full” covers many aspects, high quality, considerate after-sales service, and the most important is to grasp every single detail, chasing for perfection with an artist spirit. Fab service for makers, that's where our name come from.


Leave a Comment