TB6612FNG Dual Channel Motor Driver

TB6612FNG Dual Channel Motor Driver
The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode. Logic supply voltage (VCC) can be in the range of 2.7-5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 12VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).
Note: This module is out of stock, you can purchase the substitute: DRV8833 2 Channel DC Motor Driver Module.

Features:

  • Power supply voltage: VM=12V max, VCC=2.7-5.5V
  • Output current: Iout=1.2A(average) / 3.2A (peak)
  • Standby control to save power
  • CW/CCW/short brake/stop motor control modes
  • Built-in thermal shutdown circuit and low voltage detecting circuit
  • All pins of the TB6612FNG broken out to 0.1" spaced pins
  • Package List:

  • 1 x TB6612FNG Dual Channel Motor Driver
  • Documents:

  • Datasheet
  • Write a review

    Note: HTML is not translated!
        Bad           Good

    • Product Code: MAM6612TB
    • Availability: Out Of Stock
    • $1.75
    • 51 or more $1.70