Difference between revisions of "Lora Soil Moisture Sensor V3"

From MakerFabsWiki
Jump to: navigation, search
(Created page with " ==Introduction== The Lora soil moisture sensor V3 is based on Atmel's Atmega328P, it collects local air temperature/ humidity with sensor AHT10, and detects the soil humidit...")
 
(Using)
Line 28: Line 28:
 
==Using==
 
==Using==
 
In order to meet the requirement of the low power consumption, we provide the firmware for the low consumption and the firmware has been uploaded to the sensor before shipping. So you can use the sensor directly after unpacking it.<br>
 
In order to meet the requirement of the low power consumption, we provide the firmware for the low consumption and the firmware has been uploaded to the sensor before shipping. So you can use the sensor directly after unpacking it.<br>
* The firmware is available on Github.<br>  
+
* The firmware is available on [https://github.com/Makerfabs/Lora-Soil-Moisture-Sensor Github].<br>  
 
* When you power the sensor with 2 AAA batteries, it will transmit the soil moisture measuring through LoRa communication. Then the sensor will enter the sleep mode and wake up to work in 75 minutes. <br>
 
* When you power the sensor with 2 AAA batteries, it will transmit the soil moisture measuring through LoRa communication. Then the sensor will enter the sleep mode and wake up to work in 75 minutes. <br>
 
*
 
*

Revision as of 06:59, 27 September 2021

Introduction

The Lora soil moisture sensor V3 is based on Atmel's Atmega328P, it collects local air temperature/ humidity with sensor AHT10, and detects the soil humidity with capacitor-humility measurement solution. It can transmit the local environment data to the gateway or devices with the Lora communication, and it suits for the applications such as smart-farm, irrigation, agriculture, etc.

In applications, always you do not need to check the air/soil state continuously, have a test of them for few seconds after then minutes/hours sleeping is normally Ok for most projects. To save power, there the Air/ Soil measuring functional could be shut down in the working, so they can be only powered ON a short time and then a long time power off. With MCU in sleeping mode and low power consumption Lora module, this module can work with 2 AAA batteries for more than one year. Besides, this sensor is coated with waterproof paint, which makes it working longer in wet soil.

This is the V3 version of the Lora soil moisture sensor, you can check here for the previous one.


Features

  • Classic ATMEL AVR 8-bit Atmega328P, with Arduino Pro Mini(3.3V/8M bootloader pre-loaded)
  • Capacitor-humility measurement.
  • AHT10 temperature and humidity sensor.
  • Working with 2 AAA batteries for more than one year.
  • 3D printed case.
  • Waterproof coating.
  • Can be used directly without secondary programming.

What is hardware changed

Power consumption

Coat

When the sensor is used in the wet soil for a long time, the PCB part buried in the ground would be more and more damper, and it would cause the inaccuracy of measurement at the end of the detection. To improve the measurement accuracy and extend the service life, we made a waterproof coating for it, that can provide waterproof protection and slow down the PCB spoilage.

Using

In order to meet the requirement of the low power consumption, we provide the firmware for the low consumption and the firmware has been uploaded to the sensor before shipping. So you can use the sensor directly after unpacking it.

  • The firmware is available on Github.
  • When you power the sensor with 2 AAA batteries, it will transmit the soil moisture measuring through LoRa communication. Then the sensor will enter the sleep mode and wake up to work in 75 minutes.