Maduino Zero Canbus with RS485

From MakerFabsWiki
Revision as of 08:44, 23 October 2020 by Hefang (talk | contribs)

Jump to: navigation, search

Attention!!! This product has not been released.


Maduino Zero CANbus with RS485 is an IoT (Internet of things) Solution based on the 32-bit Atmel's SAMD21 MCU.
Modul: 4-Channel Lora Relay-10A
Maduino RS485 101.jpg


  • ATMEL SAMD21G18A: 32-bit ARM® Cortex®-M0 up to 48MHz, 256KB flash, 32KB SRAM, LQFP48v • Powered by a lithium battery (3.4-4.2V) or AC-DC Adapter.
  • Arduino Compatible: Compatible with Arduino IDE.
  • Implements CAN V2.0 at 1M/s.
  • MCP2515 CAN Bus controller and MAX3051 CAN Bus transceiver.
  • Allows for Transmission Speeds Up to 16Mbps of RS-485.
  • AutoDirection Enables Driver Automatically on Transmission of RS-485.
  • Allowing Up to 128 Transceivers on the Bus of RS-485.
  • Extended ESD Protection for RS-485 I/O Pins and CANBUS I/O Pins.
  • Integrated DB9 male connector.
  • Industrial standard 9 pins sub-D connector.
  • 5V power supply.


Maduino RS485 102.jpg
DB9 Interface:

DB9 PIN Description


Software setup

  • After installed Arduino, there is no package to support the board (Arduino zero) that is needed to be installed.
  • select tools ->Board -> Board Manager, search "Arduino zero" and install "Arduino SAMD Boards".
  • Select Tools ->Board -> Arduino Zero (Native USB Port), select Tools -> Port -> com…


Github: Maduino-Canbus-RS485

  • The sensors or devices which can carry on RS485 or CANbus are connected to the board through cables. in this project, use the same board instead of the device being tested, and connected two board by cables or Dupont Lines to check the communication between boards.
  • The pins connection is:
Maduino Zero CANbus with RS485 Devices or sensors
RS485_A RS485_A
RS485_B RS485_B


  • One board upload the code Maduino-CANbus-RS485/CAN_Sender/CAN_Sender.ino, and the other upload the code Maduino-CANbus-RS485/CAN_Receiver/CAN_Receiver.ino. Both programs include the functions which can realize receiving and sending data in RS485 communication mode and CANBUS communication mode.
  • After the upload is successful, open the Serial Monitor and you can observe that the board is receiving and sending data cyclically through CANBUS. The green indicator light on the board will flash when data is received.

Maduino RS485 103.jpg


  • Two boards upload the code Maduino-CANbus-RS485/RS485/RS485.ino.
  • After the upload is successful, open the Serial Monitor and send data through the Serial Monitor, and receive the data through RS485 communication on another board. The blue indicator light on the board will flash when data is received.

Maduino RS485 104.jpg
Maduino RS485 105.jpg


You can list your question here or contact for technology support. Detailed descriptions of your question will be helped to solve your question.


Github: Maduino-Canbus-RS485